+- ChitownRC (https://www.chitownrc.com)
+-- Forum: Main Forums (https://www.chitownrc.com/forum-4.html)
+--- Forum: Racers Forum (https://www.chitownrc.com/forum-9.html)
+--- Thread: Round vent holes in body (/thread-982.html)
Pages:
1
2
Round vent holes in body - RCDad - 09-06-2005
I'm going to use some fuel line (or something) and line the cuts. Maybe use a little glue to hold it in place.
Round vent holes in body - DAVEC-NITRO-RS4 - 09-06-2005
Tex Wrote:with George it's the other way around....lol
GO GEORGE!!!!
With a little bit bigger tires and a little bit smaller wing, you prolly could run a truggy upside down. jk.
Round vent holes in body - DAVEC-NITRO-RS4 - 09-06-2005
RCDad Wrote:I'm going to use some fuel line (or something) and line the cuts. Maybe use a little glue to hold it in place.
Just use a flame and carefully melt the edges of the openings until they smooth out. Or you could use door edge guard, found at an auto parts store. But even that stuff will come off eventually.
Round vent holes in body - snakebite46 - 09-06-2005
You could use some Shoe-goo and reinforce that area too. I did that on one body I had a seemed to work pretty good.
Round vent holes in body - DAVEC-NITRO-RS4 - 09-06-2005
snakebite46 Wrote:You could use some Shoe-goo and reinforce that area too. I did that on one body I had a seemed to work pretty good.
ShooGoo a scrap piece of lexan under the thin area and build it up to be stronger....
Round vent holes in body - RCDad - 09-06-2005
I've actually got fiberglass cloth and shoo goo for bodies, it's super strong.