+- ChitownRC (https://www.chitownrc.com)
+-- Forum: Main Forums (https://www.chitownrc.com/forum-4.html)
+--- Forum: Racers Forum (https://www.chitownrc.com/forum-9.html)
+--- Thread: Picco P3 .26 help (/thread-2313.html)
Picco P3 .26 help - Obsessive R/C - 01-24-2006
Anyone know the needle settings for a Picco P3 .26??
This thing will not start. Changed out the OWB added a P/S
I've changed the plug...eveything checks out. Messed with the needles...
It will not even sputter...seems tight w/ decent compression...
Everything seems fine, just can't get it to start. :confused:
Picco P3 .26 help - Michowski - 01-24-2006
is your glow ignitor charged?
Picco P3 .26 help - Ponch - 01-24-2006
Gas?
Picco P3 .26 help - Sh1nn3r - 01-24-2006
Take the glow plug out and put it to your ignitor see if it glows.
Then see if its fluding, take glow plug out and give it a few good tugs.
Check if your fuel lines are cloged. Prime the engine and watch if fuel is going to the engine.
Picco P3 .26 help - Czech-it-Out Graphics - 01-24-2006
u cant go wrong with leaning it out ONLY to get it started, once it starts keep a very close eye on the smoke and temps. My Xp was like 7turns out from flush on the low end and flush on top
Picco P3 .26 help - Obsessive R/C - 01-24-2006
Glow plug lights up instantly, all lines are fresh and primed, it's not flooded and igniter is fully charged....still nothing.
Any other suggestions?
Picco P3 .26 help - Michowski - 01-24-2006
do you see the fuel going through the lines and into the carb?
Picco P3 .26 help - Obsessive R/C - 01-24-2006
Yup.
Picco P3 .26 help - Michowski - 01-24-2006
make sure your needles arent closed
Picco P3 .26 help - Obsessive R/C - 01-24-2006
I think it may be something in the carb.