+- ChitownRC (https://www.chitownrc.com)
+-- Forum: Tech Forums (https://www.chitownrc.com/forum-7.html)
+--- Forum: Engine / Drivetrain (https://www.chitownrc.com/forum-17.html)
+--- Thread: Rex P5nx (/thread-3323.html)
Rex P5nx - maxximum_44 - 04-12-2006
I was looking over the instructions and noticed that Novarossi does not give any (base) needle settings, is this common among the higher end engines? :confused: I know that they're set on a flow bench at the factory, but some settings would have been nice when it comes time to re-tune. Any ballpark settings will be appreciated
Rex P5nx - kevinF - 04-12-2006
call the company and ask them
Rex P5nx - maxximum_44 - 04-12-2006
Were settings included with the P5+?
Rex P5nx - rocco79 - 04-12-2006
The best thing i would say is start it up and see if it will run... If it runs but the temps wont get too 200 degress lean it just a lil and wrap the head in foil or a sock...
Keep tunning till you reach your desired break-in temp. After your break in cycle is finished tune for power .... After that turn your needles and count the turns ... That would be your settings
Rex P5nx - rocco79 - 04-12-2006
btw ... SWEET AVATAR!!!!
Rex P5nx - maxximum_44 - 04-12-2006
Thanks and thanks
Rex P5nx - rocco79 - 04-12-2006
LOL!! anytime