+- ChitownRC (https://www.chitownrc.com)
+-- Forum: Tech Forums (https://www.chitownrc.com/forum-7.html)
+--- Forum: Engine / Drivetrain (https://www.chitownrc.com/forum-17.html)
+--- Thread: Help With Break-In (/thread-3694.html)
Pages:
1
2
Help With Break-In - UE-Maxx - 05-30-2006
I got the first five 3 minute runs and one 5 minute run of the "heat cycle" done. After I tried starting the engine after the run before, it would not start at all.
I tried richening and leaning and it won't fire. The glow plug is good. The engine is getting fuel because if I try to start it a few times, I can pour fuel out of the pipe. All batteries are fresh.
Thanks
mash:
Help With Break-In - rocco79 - 05-30-2006
flooded?
Help With Break-In - UE-Maxx - 05-30-2006
I don't think so. I cleared the engine because I thought it might have been, but it wouldn't start after that.
Help With Break-In - Traxxas_Junkee - 05-30-2006
did you have the motor apart? is the piston in back wards? sounds like what happened to revo2k.
Help With Break-In - rocco79 - 05-30-2006
I dont think he took it apart dude
Help With Break-In - rocco79 - 05-30-2006
Many times in breakin a plug that glows well may actully be bad due to the microscopic pieces of metal that have built up on it... Switch plugs make sure your not flooded and start over....
Help With Break-In - Traxxas_Junkee - 05-30-2006
rocco79 Wrote:I dont think he took it apart dude
Well, ya never know, won't hurt to ask.
Help With Break-In - UE-Maxx - 05-30-2006
rocco79 Wrote:I dont think he took it apart dude
I somewhat took it apart. The piston didn't move.
rocco79 Wrote:Many times in breakin a plug that glows well may actully be bad due to the microscopic pieces of metal that have built up on it... Switch plugs make sure your not flooded and start over....
I did switch to an OD99 because the stock one burnt out.
Help With Break-In - Czech-it-Out Graphics - 05-30-2006
when ur starting it, if it wont fire after awhile, pinch the fuel line; you are most likely flooding it, then blip the throttle to get more air in and it should start
Help With Break-In - UE-Maxx - 05-30-2006
I will try it tomorrow. Finals the next three days which means we get out early.
Help With Break-In - Czech-it-Out Graphics - 05-30-2006
finals the next three days for me too bro, gonna be a looooong week ahahahh
Help With Break-In - UE-Maxx - 05-30-2006
Need to get a B average for car insurance and it is going to be hard. I have either like 93 or higher in 2 of my classes and then the rest at 80.12 or like 83.54. 80 is a B
Help With Break-In - Czech-it-Out Graphics - 05-30-2006
cool dude good luck
Help With Break-In - Traxxas_Junkee - 05-30-2006
mine are all this week, i hope i passed my math final today, if not that means summer school, no rc, and no big vacation with all the family and friends.
Help With Break-In - Ponch - 05-30-2006
Comon dummy...Math is easy! I hope you did gud. I dun gud in englesh and bhiologee...Yeah right I think I flunked those.
Help With Break-In - kevinF - 05-30-2006
lol, good luck kyle.
I already had my finals for math, but then again it was 8th grade so it was easy. ahaha....
next year will be killer
Help With Break-In - Traxxas_Junkee - 05-30-2006
Thanks guys, OK back to his break-in thread. Sorry UE.
Help With Break-In - UE-Maxx - 05-31-2006
Traxxas_Junkee Wrote:Thanks guys, OK back to his break-in thread. Sorry UE.
It's all good as long as I get my damn engine figured out. LOL
Help With Break-In - UE-Maxx - 05-31-2006
I think Mike has the right answer. I went out to start, pinched the fuel line, and blipped the throttle and it started, but it would die from bogging down. Kinda hard to do with two hands. Just leaned the LSN a bit and it ran for about a minute. Low rx pack.
mash: Charging for an hour and I'll should be back out there.
Help With Break-In - Ponch - 05-31-2006
Sweet....
Help With Break-In - Traxxas_Junkee - 05-31-2006
i hate when that happens, get everything ready then something stupid goes wrong, o well, sounds like things are going on the right track.
Help With Break-In - UE-Maxx - 05-31-2006
Thanks for everyone's help.
I did one tank after break-in so far. This thing flies. I didn't go over half throttle because I still want to take it easy for a bit. Temps under 200. I was leaning it out, but I didn't want to go too lean without going full throttle to tune the HSN.
Thanks again. :beer:
Help With Break-In - rocco79 - 05-31-2006
what engine you running?
Help With Break-In - Czech-it-Out Graphics - 05-31-2006
get the temp up above 200. will have my new mill friday!
Help With Break-In - UE-Maxx - 05-31-2006
Novarossi 21BF. Got a good deal off someone on the grid and that is the engine I was actually looking to get.
You take the temperature of the engine on the glow plug right? If I point the gun at the plug it will read cooler than if I do near the bottom of the head.