+- ChitownRC (https://www.chitownrc.com)
+-- Forum: Tech Forums (https://www.chitownrc.com/forum-7.html)
+--- Forum: Engine / Drivetrain (https://www.chitownrc.com/forum-17.html)
+--- Thread: Brake clean + engine = ??? (/thread-6474.html)
Brake clean + engine = ??? - micro Loopie - 03-30-2007
Can I pull the engine head, back plate, and clutch off my engine, and spray it out with brake clean?
Or what would you guys recommend?
Brake clean + engine = ??? - Czech-it-Out Graphics - 03-30-2007
dont spray it out unless u sucked dirt, all that oil in there is a good thing
Brake clean + engine = ??? - micro Loopie - 03-30-2007
Ok.
Can I keep the carb, engine head, and backplate on, but take the clutch off and spray the engine exterior with brake clean to clean then engine in general?
Brake clean + engine = ??? - MX_KEVIN - 03-30-2007
I do all the time...The people next to me in the pits LOVE me for it also. :eek:
Brake clean + engine = ??? - mikeh - 03-30-2007
Yeah, I have used brake cleaner too. It does work, but I think nitro clean works better.
Brake clean + engine = ??? - Thirdgen89GTA - 03-30-2007
You can spray the internals with brake cleaner if you want, just make sure to repack the front and rear bearings with grease, as well as a thurough spray down with WD40 of the internals as you assemble it, this will provide start up lubrication till the oils in the fuel relube the engine.
Oh yeah, it'll smoke real bad for a little bit too as it works the WD40 out of the engine.
Brake clean + engine = ??? - Tex - 03-30-2007
I started my engine on straight WD40 once....it was great...smell and smoke were horrific
Brake clean + engine = ??? - Michowski - 03-30-2007
you can buy the gallons of wd-40 and just put a little in the tank and use that as your After Run lol. I used to do it all the time
Brake clean + engine = ??? - rocco79 - 03-30-2007
Michowski Wrote:you can buy the gallons of wd-40 and just put a little in the tank and use that as your After Run lol. I used to do it all the time:confused: :crazy:
lap:
Brake clean + engine = ??? - chickenfarmer3 - 03-30-2007
just use good fuel and you wont have to use after run oil.
Brake clean + engine = ??? - Czech-it-Out Graphics - 03-30-2007
werks....
you dont need to spray out the internals you shouldnt ever have to, if ur set on it take the stuff out of the case and spray them individually keep the grease/oil in those bearings
Brake clean + engine = ??? - micro Loopie - 03-30-2007
If I take thhe back plate off, can I just bolt it back on, or does it need to be resealed??
What does one use to re-seal it?
Brake clean + engine = ??? - Czech-it-Out Graphics - 03-30-2007
You can use carb seal or some RMV sealant
Brake clean + engine = ??? - billy - 03-30-2007
I've heard that WD-40 is bad for O-rings
Brake clean + engine = ??? - HAGASAN - 03-30-2007
It is, DO NOT use Wd40 on the O-rings. And you should never pack any grease in the bearings, the fuel is the lubricant. If you really want to clean the motor internals, take it apart and clean it with nitro cleaner or alcohol. You can clean and scrub the case with simple green and a brush. You can rinse it off with water after you scrub it, but as soon as your done run some fuel and or afterun oil all over the inside. If the oring on the backplate is good, just put a few drops of oil on it and seal it up, you really dont need any sealer on it.
Brake clean + engine = ??? - motoxer4life - 03-31-2007
what do you guys use to seal engines? i never even knew you had to but now i hear alo of people are doing it.
Brake clean + engine = ??? - UE-Maxx - 03-31-2007
Racer's choice air seal.
Brake clean + engine = ??? - rocco79 - 03-31-2007
oxygen sensor safer gasket material
![[Image: perm80022.jpg]](http://www.caswellplating.com/permatex/images/perm80022.jpg)
Brake clean + engine = ??? - motoxer4life - 03-31-2007
do they all work the same? i just want to know if theyre easy to pull of in cas ei have to send the engine in to get it fixed.
Brake clean + engine = ??? - Ponch - 03-31-2007
Well it's a sealant so obviously it's going to be like a glue to bond the 2 together and they're going to be stuck pretty good. I've tried to take the backplate off of a rocco-sealed engine and it was a b!tch.... That blue stuff is a super tight hold but probably works great. I use what UE Maxx posted up and works fine too.
Brake clean + engine = ??? - motoxer4life - 03-31-2007
ok thanks ill probably get the racers choice stuff if i can find it in stock anywhere.lol.
Brake clean + engine = ??? - Ponch - 03-31-2007
I got it at LH a while back.
Brake clean + engine = ??? - motoxer4life - 03-31-2007
alright ill call them ween i get chance thax every1.
Brake clean + engine = ??? - motoxer4life - 03-31-2007
you dont really need sealer untill it leaks right?
Brake clean + engine = ??? - Thirdgen89GTA - 03-31-2007
motoxer4life Wrote:you dont really need sealer untill it leaks right?
Yes. The rubber orings in the carb, and on the block, and rear cover plate should prevent air leaks as long as you installed them with some lubricant to prevent tearing of the o-rings.
But as o-rings get old, they shrink and become brittle, losing their elasticity. Thats when an air leak will make itself known.