+- ChitownRC (https://www.chitownrc.com)
+-- Forum: Tech Forums (https://www.chitownrc.com/forum-7.html)
+--- Forum: Electronics / Radio (https://www.chitownrc.com/forum-19.html)
+--- Thread: 3rd channel and 2nd channel operating one in the same? (/thread-8211.html)
3rd channel and 2nd channel operating one in the same? - Ponch - 01-30-2008
Ok... on my crawler, the 2nd channel (to esc) and the 3rd channel (to servo) are kind of....well mixing. When I pull or push the trigger on the radio (XS3) the 3rd channel servo also moves. While not much, it does piss me off...lol.
Any ideas why this is happening???
3rd channel and 2nd channel operating one in the same? - Ponch - 01-30-2008
Actually... It's doing it with both throttle and steering. WTF?
3rd channel and 2nd channel operating one in the same? - Ponch - 01-30-2008
Got it...NVM.
3rd channel and 2nd channel operating one in the same? - bubbaracing - 01-31-2008
So how do ya set that 3rd channel up on the XS3 since I won't have my Hitec radio ready in time for the comp?
3rd channel and 2nd channel operating one in the same? - Ponch - 01-31-2008
Hold scroll and channel, and then turn on radio.
Set AUX to 2P and GBC to 2P.
Turn off radio and turn back on.
Go into your settings like normal, get to mix, set everything at 0 (that was my problem)
Then just set your epa's and everything on the third channel according to how far you want your servo to go etc. My epa's on my dig are set at 100 both ways.
Got any q's ask.
