+- ChitownRC (https://www.chitownrc.com)
+-- Forum: Main Forums (https://www.chitownrc.com/forum-4.html)
+--- Forum: Racers Forum (https://www.chitownrc.com/forum-9.html)
+--- Thread: rc10gt clutch problems (/thread-871.html)
rc10gt clutch problems - bigjs - 08-11-2005
I bought a new engine for my rc10gt and now after putting it back together the clutch bell and spur gear do not spin freely. It seems like something is holding it up on the clutch bell. I installed the 4 in 1 clutch shoes. Any ideas of what could be wrong?
Thanks
rc10gt clutch problems - Tex - 08-12-2005
hmmm. did you check the CB before you installed the motor to make sure the CB spins freely?
rc10gt clutch problems - Mr. Tune - 08-12-2005
Mesh too tight?
rc10gt clutch problems - dentguy92 - 08-12-2005
you need a clutch shim kit...the shaft is to short and your cb screw is tight to your bearing...
rc10gt clutch problems - DAVEC-NITRO-RS4 - 08-13-2005
Bigjs,
Hold the vehicle closer to your monitor so I can get a better look at the problem......
dentguy, my kid wears a shirt that says " I start being nicer if you'll stop being an idiot". That goes well with your signature line.
rc10gt clutch problems - Obsessive R/C - 08-13-2005
:bustingup
DAVEC-NITRO-RS4 Wrote:Bigjs,
Hold the vehicle closer to your monitor so I can get a better look at the problem......
dentguy, my kid wears a shirt that says " I start being nicer if you'll stop being an idiot". That goes well with your signature line.