Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Davis Diesel Development
#1
Anybody ever try one of their diesel conversions on a car or truck?
Reply
#2
Never mind, they don't run pump diesel in these motorsSad
Reply
#3
There is a thread on the traxxas forumes of someone who bought one.
I’ve got a fever. And the only prescription is more cowbell.
Reply
#4
The deisel is still 30$ a gallon
Reply
#5
So it defeats the whole purpose to convert to deisel, if its not the pump deisel, which is about 5bucks a gallon, you might as well just stick with Nitro.
Reply
#6
Yup,that was my thought on it too!
Reply
#7
has anyone tried the conrod they make for the 3.3 motor? does it effect performance being so much more bulky?
Mugen MBX5T
RBS5
RB2045
Futaba 3PM
Hitec 5955, 5965
Reply
#8
Don't know. Supposedly it's stronger, but if it screws with the air/fuel mixtures blend and or adds additional rotating mass to the engine, would it be effective?
Reply
#9
Might make it stronger but you're losing the rev and some efficiency since you're losing that knife-edge cut on the rod.
LSP lots of Khz, Werks .28 8 port.

Revo 2.5, TRX 3.3 Engine, Center Diff. Fast and Turns on a dime.
Reply
#10
i talked to this guy who answered there phone and he talked my ear off for about two and a half hours, i called to get info on the possibility of using there head on an old motor, during the entire convo i never got my question answered. they are a little strange over at davis. products seem good though. i might be converting a 4.1 from hpi
Reply


Forum Jump:


Users browsing this thread: 4 Guest(s)