bearing troubles!

[squirrel]

I recently bought a trx 2.5 to stick in my xxx-nt. The problem comes in the clutchbell. I have to use the losi clutchbell that came with my mach .15 because if i don't the other clutchbell i have rubs the spur. My other prob is the bearings I need bearings with a 3/8 in o.d and whatever size i.d. to fit the crankshaft of a 2.5. Do they even make these sizes?

thanks for the help

[FreeRideFrosty]

Time to start trimming. LoL I don't remember what size bearings those are but I am almost positive they will have them. I thought they were all metric sizes though...

[snakebite46]

3/8th OD for a CB ? You sure about that ?

[FreeRideFrosty]

3/8th OD for a CB ? You sure about that ?

for some reason I saw 5/8... 3/8 is really small... In that case I don't know if you can get it to fit the 2.5. Run the 2.5 clutch and make it fit...

[squirrel]

If i want to use the other clutch bell i would have to move the trans forward or the motor back! I'll check and see what the rustler c b looks like

[deranged01]

hey squirrel back up off of my rustler you want my pieces you can buy your own not steal mine

[Traxxas_Junkee]

i have a bunch of rustler stuff if u need it.

[deranged01]

yea rustler stuff would be great what do you have and what do you want i ran mine into a curb at full speed before i even paid for it five minutes after i got to drive it so now squirrell is trying to teach me to tear it down and rebuild.

[squirrel]

Got the rusteler c.b. to work!!!! Perfect width! I am going to hobbytown tomorrow to pick up on for me and to get a few other parts! yay!!