Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Dang it, first problem appears with the revo.
#1
The freaking engine runs hotter than hell! Even with good smoke coming out the back. During break in it was like 240*. I had to richen it more than the factory setting just to keep the temps down.

After five tanks of break in (follow the procedures in the book), I started mashing the throttle only to find out that the temps are consistently around 250* without changing the hsn from the break in setting.

What's going on here? Any of you other revo guys had this problem or heard of it? Possible fixed. I'm not too impressed at the moment with the speed because it's so bloody rich just to keep the temps down. Hell, you can see fuel dripping out of the exhaust when it's sitting there idling.
Reply
#2
I ran my 2.5 at 260. Most people with the TRX run at those temps. I hope that helps.
Reply
#3
The 2.5R has more compression right? That might account for the higher temps.
Reply
#4
I'm not worried about running it at 260 or even 270. The problems lies in the fact that in needs to be rish as hell just to stay at those temps. It takes quite a bit of time to hit second gear because it's so rich. Any leaner and I'm gonna start seeing 300+ temps.
Reply
#5
Ok, just got finished running it for the day. As the 7th tank was nearing completion, I noticed the temp were down a little more than before. I leaned it out a tad and temps climbed only slightly, so I leaned it out some more. Now this thing is starting to run like I think (fast Smile) with decent temps. Pretty cool.

I go to unscrew the glow plug so I cam throw in some after run oil and what do you know. I barely started to turn it and it was real loose. That think was barely tight at all!! You think this could be the culprit? If so, I can only blame myself for trusting the qc over at traxxas and not going throught he truck myself. I'm gonna run it for another 2-3 more tanks tommorrow for some test and tune with a tight glow plug and see what happens Smile.

Me revo saga contines...Smile
Reply
#6
good luck, also what fuel are you using? 33% top fuel and the 2.5r is just a sweet combo.
Reply
#7
Something I've learned about new motors. I dont trust the QC of the manufacter. EVERY motor I get I flush the motor before running it the first time. I completly disassemble the entire thing and flush it out with denat alchohol. I did that with my 2.5r and it still looks good on the inside. Even I havent ran it in awhile =). I did the same with my OS TM and my NR P5. I got 8 gallons out of that motor and it still looks good on the inside.

Some of the early Revo's, had problems with debris in the tanks and would cause pre-mature engine failures.
Reply
#8
I got a little more than 1/2 gallon of 33% Top Fuel if your interested Mr.Tune. I switched to running the same fuel in all my stuff.
Reply
#9
mich, I'm using trinity hosepower 20%
Reply
#10
Watch your connections!!! The O-Ring on the gas tank leaks badly and leans out the mixture raising temps. Also, watch the header coupler as it gets a split and leaks reducing pressure to the tank.
Reply
#11
I've been on the traxxas board for like the last hour or so readinf up on the revo. I did catch that gas tank leak on quite a few threads. I checked it out and there's no gas anywhere on the tank and it feels solid when I close the lid. Looks good to me. I also tried the tip of pulling off the air cleaner and plugging the hole with my finger. No air leaks should make the engine shut down immediately when plugging the hole. Did that too. I then fired it up and drove some more and the temps were down dramatically somehow, lol.

Tommorrow I'll run some more and see what I find.
Reply
#12
My stock Revo runs 250-270 depending on how rich I want to run it. When you lean it to the point where it really starts making power, it's quickly up to 270-300, but still a little smoke under full throttle. When it gets that hot the engine really starts smoking and burning off any crud. But it hauls! I just don't feel like using the engine up under those tuning conditions.

I use OD's 20% fuel with the Traxxas #3232 plug and we have around 2 gallons through it. We did adjust the shift point to be a little earlier to allow for the tune.
Reply
#13
All I gotta say Tune is.......lean it more. Those motors like 280-300F. I ran my 2.5 for 5 gallons at 300F and it ran sweet. Smallblock motors run hotter than big blocks, it's a known fact.

Heres a short story. Rich was having power problems at Leisure when his revo was fairly new. He was running TRX 33% in the 2.5R at the time. I said "let me tune it" and he said "sure". When I was done it was rippin' balls all over the place and when I temped it, it said 287F. Moral of the story is those motors like it hot. (for good performance anyway).

Heres a question for you Tune, would you rather get 8 "slow" gallons, OR 5 "fast" gallons through the motor? Just as an example.
Mugen MBX5T
RBS5
RB2045
Futaba 3PM
Hitec 5955, 5965
Reply
#14
Vent your body, too. The truck body I mean.
Reply
#15
George can back me up on this one... We see more revos/t maxxs at the lhs that we somtimes hangout at cuz our buddy works there go through pistion and sleeves like crazy!!!
Maybe it because traxxas has advertised its products so well as beginner friendly and its alota newbies not knowing how too tune... from my short experince with the 2.5.... I dont like it BUT thats just my opinion!!! Im not saying its not good, im just saying is from my experince is that i dont like this motor at all.
Dont mess wit my sig Line tune!
--Then follow the rules! haha!-- -Tune
Reply
#16
the 2.5 is finicky and needs a decent tuner to run well and last a long time.

Your right rocco, traxxas markets their stuff for noobs so that's why so many P/s blow.
Mugen MBX5T
RBS5
RB2045
Futaba 3PM
Hitec 5955, 5965
Reply
#17
Tex

Im sure thats what 80 to 90% of the failures are. If it were me though id pull that motor and put an O.S. TM like mich's in there!!! Very faaaaasssst
Dont mess wit my sig Line tune!
--Then follow the rules! haha!-- -Tune
Reply
#18
me too.......... Smile
Mugen MBX5T
RBS5
RB2045
Futaba 3PM
Hitec 5955, 5965
Reply
#19
amazing power for an .18!!!
Dont mess wit my sig Line tune!
--Then follow the rules! haha!-- -Tune
Reply
#20
I was thinking about putting my OS 18 in my 11lb Dom hybrid it has sooo much power.
Mugen MBX5T
RBS5
RB2045
Futaba 3PM
Hitec 5955, 5965
Reply
#21
try it!!!!!
Dont mess wit my sig Line tune!
--Then follow the rules! haha!-- -Tune
Reply
#22
it has a side exhaust pointing the complete wrong way.
Mugen MBX5T
RBS5
RB2045
Futaba 3PM
Hitec 5955, 5965
Reply
#23
D'oh!!!
Dont mess wit my sig Line tune!
--Then follow the rules! haha!-- -Tune
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  E-Revo Brushless Edition? Summit? J-Dub 2 3,553 10-26-2008, 08:23 AM
Last Post: Fastlane GraphiX
  Batteries for stock e revo ricketki 4 6,203 08-05-2008, 06:40 PM
Last Post: BJoe
  Tower hobbies is giving away Platnium REVO's! Whoo Hoo! team3six 20 6,827 04-03-2008, 06:20 PM
Last Post: Toughtrax
  Revo, a race truggy? snoracer 61 14,488 02-13-2008, 05:27 PM
Last Post: J-Dub
  Traxxas Revo.... J-Dub 42 8,701 11-10-2007, 08:41 PM
Last Post: Michowski
  Quick Revo Diff question stratcat 12 3,600 08-10-2007, 04:55 PM
Last Post: DAVEC-NITRO-RS4
  Mugen problem motoxer4life 19 3,731 07-30-2007, 09:37 AM
Last Post: motoxer4life
  Revo? Whitey04 33 7,269 05-27-2007, 09:00 PM
Last Post: J-Dub
  vantage one-way axle for 3.3 revo Meatwad 5 2,439 05-21-2007, 09:25 PM
Last Post: hansarvin
  Dang that was long Rawkfist_02 17 2,821 03-22-2007, 09:57 AM
Last Post: Rawkfist_02

Forum Jump:


Users browsing this thread: 4 Guest(s)