08-19-2005, 06:29 PM
I have a Mugen MBX-4 buggy that at full compression on the front suspension (like landing off a jump) the front CVD pin pulls out of the drive cup at the diff and the axle comes out. It's almost like the drive cup is in too far or the axle is too short. At ride height the pin sits 1/16th in from the edge of the cup. Most others I've seen sit towards the center of the cup. The only way I can keep them in is by setting the stops so low that it limits travel. The pillow balls are in as close as possible without binding at full lock. Any ideas here as to what the problem might be??