spektrum set up with jammin?

[Thirdgen89GTA]

I've got my endpoints set perfect on my DX3 system.

First, take the throttle and steering arms off the servo's.

Then, set all of your trim at 0, and your endpoint at 100 on the DX3.

Turn on the tx, and rx. The servo's should center themselves. Make sure that the servo's are set to the proper direction.

Now, eyeball it and center your steering and throttle arms as best you can.

Once that is done, adjust the end points so it doesn't bind, or try and pull the throttle slide out of the carb. Your throttle servo should stop pulling on the slide exactly, as the slide reaches maximum travel (full throttle).

Its not very hard, though it can be confusing if you've never had a radio that has those functions. Read through the DX3 manual, it has all of this information in the manual.

Once you get the basics done, you can go outside, start it up, and then adjust your subtrim, steering throw, and throttle/brake travel so you aren't overheating the servo's by overdriving them or binding the steering/throttle/brake linkage.