11-26-2006, 09:28 PM
Didn't realize it was the championships, then the week after.
The front axle where the cvd pin goes in, is drilled off center. It is hard to push the pin through with the cvd in there because it doesn't line up, and if I can get the pin in, it binds up and can't move at all.
Everything is really smooth, except my front diff. Feels little tight, but people on the grid said it will loosen up after it is run.
The front axle where the cvd pin goes in, is drilled off center. It is hard to push the pin through with the cvd in there because it doesn't line up, and if I can get the pin in, it binds up and can't move at all.
Everything is really smooth, except my front diff. Feels little tight, but people on the grid said it will loosen up after it is run.