12-09-2006, 04:43 PM
Casketman Wrote:But I would think that if you grind down that part on the pin,and use thread locker on the set screw. You shouldnt have a problem.
Chad,that pin did you tell me you used? The HPI hellfire pin?
i think it was from a hellfire or a LSP not sure but it was just a hair short, i think grinding the mugen ones would be the best bet.
anyone know if white lithium grease will work ok in the place of that mugen super joint chit?? always worked great on the kyosho ring and pinions, only lost one set in 4 months.
GS RACING, TQ FUEL, FASTLANE GRAPHIX, CZECH-IT-OUT