12-09-2006, 06:44 PM
Just so you know, I use 1 gasket on diffs. There were tight at first but have broke in nicely and dont leak, but I did sand the cups flat. No shims at all. Again was tight at first but broke in nicely. And I did have a wheel extender fall off on the first run because I wasnt used to really tightening that set screw on my buggy, but since theyve been cranked down with loctite, no problems. Axles have been flawless. Those I knew better .
I did have the clutch bearing go out with less than a gallon on it which messed up my spur and clutch bell, Advids are better IMO...
I did have the clutch bearing go out with less than a gallon on it which messed up my spur and clutch bell, Advids are better IMO...
MBX5T - O.S.
MBX5R - Novarossi
Nomadio