01-14-2007, 12:38 AM
I use an 1/8 inch drill bit in my dremel. I make 4 holes in the center of the tread part of the tire. 3, 6, 9, 12 (like a clock).
Using the drill bit in a dremel with light pressure makes a clean hole without jagged edges to be more prone to tearing.
I do this on MT tires, so if your running 1/10 scale, you might only need two or use a smaller bit.
Using the drill bit in a dremel with light pressure makes a clean hole without jagged edges to be more prone to tearing.
I do this on MT tires, so if your running 1/10 scale, you might only need two or use a smaller bit.