01-17-2007, 10:04 PM
#71 of 89 by Bobby Phillips (superpb) on Fri Jan 12 10:44:56 2007:
Bob, http://www.HTBatteries.com is another source also.
--------------------------------------------------------------------------------
#72 of 89 by Tink! (re270) on Fri Jan 12 18:57:54 2007:
+1 HT Batteries
--------------------------------------------------------------------------------
#73 of 89 by JIM COUCH (ctek) on Fri Jan 12 20:56:09 2007:
Can the FASST receiver handle 7.2 volts without a regulator? I run a
7.2 lipo now with a regulator but it would be nice not to have to use
one.
--------------------------------------------------------------------------------
#74 of 89 by Eric Beier (yzlvr) on Fri Jan 12 22:33:29 2007:
Jim the 2 cell pack is 8.4V fully charged, so that is when you need
the 6V regulator.
--------------------------------------------------------------------------------
#75 of 89 by Michael Kwiatkowski (hopper) on Sat Jan 13 00:34:05 2007:
Jeff... if your running HRS don't forget to set the failsafes on the
radio...
--------------------------------------------------------------------------------
#76 of 89 by Jeff Schwartz (jeffs) on Sat Jan 13 01:04:07 2007:
I have one analog servo out of 4, so I have to run PPM.
Have fun in Tahoe this weekend, I bet it's gonna be brrr'fing'brrrr up
there...
--------------------------------------------------------------------------------
#77 of 89 by James T. Little (jtlittle) on Sat Jan 13 22:53:56 2007:
Is anyone running any radio without a reulator and 2 cell lipo.
--------------------------------------------------------------------------------
#78 of 89 by Adam Joiner (adam490) on Sun Jan 14 00:25:02 2007:
Joor was for a while.
--------------------------------------------------------------------------------
#79 of 89 by Eric Beier (yzlvr) on Sun Jan 14 06:33:47 2007:
you will burn up your servos after a while
#80 of 89 by Jeff Schwartz (jeffs) on Sun Jan 14 15:02:39 2007:
The main issue isn't running at 7.2v, it's running a freshly peaked pack
that measures out at almost 9v.
--------------------------------------------------------------------------------
#81 of 89 by vito (vitopela) on Mon Jan 15 11:13:35 2007:
James I'm running always a 2 cell lipo without regulator and i don't
have any issues with servos or receiver. I don't know if FASST
receiver can handle 7,2v.
--------------------------------------------------------------------------------
#82 of 89 by Aaron Sikes (asikes) on Mon Jan 15 18:19:43 2007:
Anyone have the aluminum plug that will screw into the futaba antenna
hole after a Fasst system is installed?
I remember them in a magazine, but it was over 4 months ago.
--------------------------------------------------------------------------------
#83 of 89 by Jeff Schwartz (jeffs) on Mon Jan 15 18:42:52 2007:
KMW makes them, but their site shows out of stock:
http://www.kmwracing.com/cart/home.php?cat=251
--------------------------------------------------------------------------------
#84 of 89 by Bryan P. (bp) on Mon Jan 15 20:54:19 2007:
Check with Peter Martin at TKO. That's where I got mine. He sells the
KMW stuff.
--------------------------------------------------------------------------------
#85 of 89 by Aaron Sikes (asikes) on Wed Jan 17 19:17:10 2007:
I ordered it from TKO, thanks Bryan.
Going to make the switch from Airtronics.
--------------------------------------------------------------------------------
#86 of 89 by Bobby Phillips (superpb) on Wed Jan 17 19:50:43 2007:
Glad to hear Aaron
--------------------------------------------------------------------------------
#87 of 89 by Jim Larrimore (jimsxcar) on Wed Jan 17 20:30:39 2007:
Everyone is jumping ship to Futaba.
Good stuff.
--------------------------------------------------------------------------------
#88 of 89 by John Perez (jpz67) on Wed Jan 17 23:37:28 2007:
Futaba quality is second to none. I have been a huge supporter of
airtronics equipment for 6 years but here recently it seems there
product has went down hill. I cannot keep airtronics servos in my
vehicles, and dont get me wrong I am no rookie, I know how to install
and maintain my electronics but they just dont last. Since my switch to
futaba everything has been great so far, but only time will tell on the
overall longevity and reliability.
--------------------------------------------------------------------------------
#89 of 89 by Aaron Sikes (asikes) on Thu Jan 18 03:01:43 2007:
Yeah. got my 2.4 today, still no radio. It looks fast though.
Bob, http://www.HTBatteries.com is another source also.
--------------------------------------------------------------------------------
#72 of 89 by Tink! (re270) on Fri Jan 12 18:57:54 2007:
+1 HT Batteries
--------------------------------------------------------------------------------
#73 of 89 by JIM COUCH (ctek) on Fri Jan 12 20:56:09 2007:
Can the FASST receiver handle 7.2 volts without a regulator? I run a
7.2 lipo now with a regulator but it would be nice not to have to use
one.
--------------------------------------------------------------------------------
#74 of 89 by Eric Beier (yzlvr) on Fri Jan 12 22:33:29 2007:
Jim the 2 cell pack is 8.4V fully charged, so that is when you need
the 6V regulator.
--------------------------------------------------------------------------------
#75 of 89 by Michael Kwiatkowski (hopper) on Sat Jan 13 00:34:05 2007:
Jeff... if your running HRS don't forget to set the failsafes on the
radio...
--------------------------------------------------------------------------------
#76 of 89 by Jeff Schwartz (jeffs) on Sat Jan 13 01:04:07 2007:
I have one analog servo out of 4, so I have to run PPM.
Have fun in Tahoe this weekend, I bet it's gonna be brrr'fing'brrrr up
there...
--------------------------------------------------------------------------------
#77 of 89 by James T. Little (jtlittle) on Sat Jan 13 22:53:56 2007:
Is anyone running any radio without a reulator and 2 cell lipo.
--------------------------------------------------------------------------------
#78 of 89 by Adam Joiner (adam490) on Sun Jan 14 00:25:02 2007:
Joor was for a while.
--------------------------------------------------------------------------------
#79 of 89 by Eric Beier (yzlvr) on Sun Jan 14 06:33:47 2007:
you will burn up your servos after a while
#80 of 89 by Jeff Schwartz (jeffs) on Sun Jan 14 15:02:39 2007:
The main issue isn't running at 7.2v, it's running a freshly peaked pack
that measures out at almost 9v.
--------------------------------------------------------------------------------
#81 of 89 by vito (vitopela) on Mon Jan 15 11:13:35 2007:
James I'm running always a 2 cell lipo without regulator and i don't
have any issues with servos or receiver. I don't know if FASST
receiver can handle 7,2v.
--------------------------------------------------------------------------------
#82 of 89 by Aaron Sikes (asikes) on Mon Jan 15 18:19:43 2007:
Anyone have the aluminum plug that will screw into the futaba antenna
hole after a Fasst system is installed?
I remember them in a magazine, but it was over 4 months ago.
--------------------------------------------------------------------------------
#83 of 89 by Jeff Schwartz (jeffs) on Mon Jan 15 18:42:52 2007:
KMW makes them, but their site shows out of stock:
http://www.kmwracing.com/cart/home.php?cat=251
--------------------------------------------------------------------------------
#84 of 89 by Bryan P. (bp) on Mon Jan 15 20:54:19 2007:
Check with Peter Martin at TKO. That's where I got mine. He sells the
KMW stuff.
--------------------------------------------------------------------------------
#85 of 89 by Aaron Sikes (asikes) on Wed Jan 17 19:17:10 2007:
I ordered it from TKO, thanks Bryan.
Going to make the switch from Airtronics.
--------------------------------------------------------------------------------
#86 of 89 by Bobby Phillips (superpb) on Wed Jan 17 19:50:43 2007:
Glad to hear Aaron
--------------------------------------------------------------------------------
#87 of 89 by Jim Larrimore (jimsxcar) on Wed Jan 17 20:30:39 2007:
Everyone is jumping ship to Futaba.
Good stuff.
--------------------------------------------------------------------------------
#88 of 89 by John Perez (jpz67) on Wed Jan 17 23:37:28 2007:
Futaba quality is second to none. I have been a huge supporter of
airtronics equipment for 6 years but here recently it seems there
product has went down hill. I cannot keep airtronics servos in my
vehicles, and dont get me wrong I am no rookie, I know how to install
and maintain my electronics but they just dont last. Since my switch to
futaba everything has been great so far, but only time will tell on the
overall longevity and reliability.
--------------------------------------------------------------------------------
#89 of 89 by Aaron Sikes (asikes) on Thu Jan 18 03:01:43 2007:
Yeah. got my 2.4 today, still no radio. It looks fast though.
Here is a link to my website-
http://www.czech-it-out-graphics.com
1/29/07 never forget....TTT alute:
Bringing old know-it-all blow hards back to reallity at a forum near you
"Always Imitated, Never Duplicated"
http://www.czech-it-out-graphics.com
1/29/07 never forget....TTT alute:
Bringing old know-it-all blow hards back to reallity at a forum near you
"Always Imitated, Never Duplicated"