ChitownRC › Tech Forums › Chassis / Suspension v
1pc CNC motor mount for LSP??

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
1pc CNC motor mount for LSP??
Czech-it-Out Graphics Offline
Posting Freak
*****
Posts: 13,431
Threads: 106
Joined: Nov 2005
Reputation: 0
#5
01-19-2007, 08:52 PM
i doubt that caused the problem to be honest. an engine doesnt have to have mechanical pinch to be good, MOST motors these days run the best with no mechanical pinch its all about actual compression and seal b/w the piston and sleeve. Unless it starts running sporadically with a terrible tune and high idle just run it
Here is a link to my website-
http://www.czech-it-out-graphics.com
1/29/07 never forget....TTT Confusedalute:
Bringing old know-it-all blow hards back to reallity at a forum near you

"Always Imitated, Never Duplicated"
Website Find
Reply


Messages In This Thread
1pc CNC motor mount for LSP?? - by Thirdgen89GTA - 01-19-2007, 07:33 PM
1pc CNC motor mount for LSP?? - by Tex - 01-19-2007, 08:05 PM
1pc CNC motor mount for LSP?? - by Thirdgen89GTA - 01-19-2007, 08:40 PM
1pc CNC motor mount for LSP?? - by Czech-it-Out Graphics - 01-19-2007, 08:52 PM
1pc CNC motor mount for LSP?? - by Tex - 01-19-2007, 09:07 PM
1pc CNC motor mount for LSP?? - by Thirdgen89GTA - 01-19-2007, 09:16 PM
1pc CNC motor mount for LSP?? - by Thirdgen89GTA - 01-19-2007, 10:28 PM
1pc CNC motor mount for LSP?? - by Tex - 01-19-2007, 11:29 PM
1pc CNC motor mount for LSP?? - by Thirdgen89GTA - 01-20-2007, 12:16 AM
1pc CNC motor mount for LSP?? - by MX_KEVIN - 01-20-2007, 01:53 AM
1pc CNC motor mount for LSP?? - by Thirdgen89GTA - 01-20-2007, 10:33 AM
1pc CNC motor mount for LSP?? - by Tex - 01-20-2007, 08:43 PM
1pc CNC motor mount for LSP?? - by MX_KEVIN - 01-20-2007, 09:09 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  one peice mount JOE 3 2,621 02-18-2006, 05:13 AM
Last Post: JOE

Forum Jump:


Users browsing this thread: 1 Guest(s)