ChitownRC › Tech Forums › Chassis / Suspension v
1pc CNC motor mount for LSP??

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
1pc CNC motor mount for LSP??
Tex Offline
Super Moderator
******
Posts: 9,001
Threads: 126
Joined: Jul 2004
Reputation: 0
#10
01-19-2007, 11:29 PM
did you do the flop test with the hole in the crankcase? that would cause it to have no compression and flop over right away. Once it's all sealed back up with a new case I would try the flop test again.
Mugen MBX5T
RBS5
RB2045
Futaba 3PM
Hitec 5955, 5965
Find
Reply


Messages In This Thread
1pc CNC motor mount for LSP?? - by Thirdgen89GTA - 01-19-2007, 07:33 PM
1pc CNC motor mount for LSP?? - by Tex - 01-19-2007, 08:05 PM
1pc CNC motor mount for LSP?? - by Thirdgen89GTA - 01-19-2007, 08:40 PM
1pc CNC motor mount for LSP?? - by Tex - 01-19-2007, 09:07 PM
1pc CNC motor mount for LSP?? - by Thirdgen89GTA - 01-19-2007, 09:16 PM
1pc CNC motor mount for LSP?? - by Thirdgen89GTA - 01-19-2007, 10:28 PM
1pc CNC motor mount for LSP?? - by Tex - 01-19-2007, 11:29 PM
1pc CNC motor mount for LSP?? - by Thirdgen89GTA - 01-20-2007, 12:16 AM
1pc CNC motor mount for LSP?? - by MX_KEVIN - 01-20-2007, 01:53 AM
1pc CNC motor mount for LSP?? - by Thirdgen89GTA - 01-20-2007, 10:33 AM
1pc CNC motor mount for LSP?? - by Tex - 01-20-2007, 08:43 PM
1pc CNC motor mount for LSP?? - by MX_KEVIN - 01-20-2007, 09:09 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  one peice mount JOE 3 2,621 02-18-2006, 05:13 AM
Last Post: JOE

Forum Jump:


Users browsing this thread: 1 Guest(s)