04-02-2007, 11:54 PM
its not that easy.
the best way to get them out really is with a bearing puller. you can just tap the front out but if u use the puller on the rear bearing its useless. you can put it in the oven at like 300 for 15 minutes or so and try tappin the case against a cutting board or something but i never was very succesfull in that lol
the best way to get them out really is with a bearing puller. you can just tap the front out but if u use the puller on the rear bearing its useless. you can put it in the oven at like 300 for 15 minutes or so and try tappin the case against a cutting board or something but i never was very succesfull in that lol
Here is a link to my website-
http://www.czech-it-out-graphics.com
1/29/07 never forget....TTT
alute:
Bringing old know-it-all blow hards back to reallity at a forum near you
"Always Imitated, Never Duplicated"
http://www.czech-it-out-graphics.com
1/29/07 never forget....TTT
alute:Bringing old know-it-all blow hards back to reallity at a forum near you
"Always Imitated, Never Duplicated"