04-03-2007, 09:09 AM
DAVEC-NITRO-RS4 Wrote:I should clarify ( I must do this more often) I didn't trim the foams to make them narrower. I eased the edge by cutting an 1/8" chamfer on the inner edge to make it a tad easier to seat the bead. The rest of the foam is still full width (much wider than the tire was).
+1. The ONLY reason to trim foams is to make it easier to seat the bead. If you dont you can end up actually glueing the foaf to the wheel. Just makes it a littl eeasier. Only trim inside edge a little.