10-01-2005, 10:06 PM
round here its going to be tough to get any crawling parts. I say just pick up a new clod and sell off the hardbody and all other parts other than the axles. I did that for one of my crawlers when I had them and got almost $100 back.
For the links I made my own out of soild aluminum rod. I drilled and taped the ends and lock tighted a screw into there then cut the end off. Also there are places that will build any length rods you want. Check out RC4WD.com, RCguy.com chassis are wicked too. There is just soo much you cna do with a set of clod axles.
For the links I made my own out of soild aluminum rod. I drilled and taped the ends and lock tighted a screw into there then cut the end off. Also there are places that will build any length rods you want. Check out RC4WD.com, RCguy.com chassis are wicked too. There is just soo much you cna do with a set of clod axles.
-- John --
1:1.. 01 Z28 Camaro A4 Sure.. its stock.
1:8's.. K3, Inferno GT, and a straight line beater car
1:18.. RC18t Mamba and 3s lipo
1:1.. 01 Z28 Camaro A4 Sure.. its stock.
1:8's.. K3, Inferno GT, and a straight line beater car
1:18.. RC18t Mamba and 3s lipo