04-17-2007, 10:43 PM
Take the mill out
Plug up the exhaust port with your finger.
Put some fuel line on the carb.
Blow into the tubing (while plugging the exhaust port) and spray all over the motor with a mild solution of soapy water concentrate on the carb and backplate areas---if you see it bubble---you have a leak.
what about the low end needle setting if you have temps at 250
Does it snap when you give it throttle and drop back down on the idle right away?
Plug up the exhaust port with your finger.
Put some fuel line on the carb.
Blow into the tubing (while plugging the exhaust port) and spray all over the motor with a mild solution of soapy water concentrate on the carb and backplate areas---if you see it bubble---you have a leak.
what about the low end needle setting if you have temps at 250
Does it snap when you give it throttle and drop back down on the idle right away?
Life is like Beavers, One Damn thing after another- Unknown
If your not breakin parts your not going fast enough-Biodragen
NTC3 RTR assoc .15
NTC3 OS .18
Losi 8T, JR8611a ST servo, Futaba 9350 Th\Brk Servo, RB-C6BB Motor and Novarossi 528XR.
If your not breakin parts your not going fast enough-Biodragen
NTC3 RTR assoc .15
NTC3 OS .18
Losi 8T, JR8611a ST servo, Futaba 9350 Th\Brk Servo, RB-C6BB Motor and Novarossi 528XR.