04-25-2007, 02:12 AM
:bustingup Goodman
Bent the chassis rails today out of 1/2 square tube stock. Used my benzomatic propane torch and bench vice. I just started bending the tube with the heat and a little force.
I then cut the tube down the middle with my bandsaw spliting it in two.
Ended up with two identical chassis rails.
Got a good start, I made the chassis rails too long as so I can cut them later.
Bent the chassis rails today out of 1/2 square tube stock. Used my benzomatic propane torch and bench vice. I just started bending the tube with the heat and a little force.
I then cut the tube down the middle with my bandsaw spliting it in two.
Ended up with two identical chassis rails.
Got a good start, I made the chassis rails too long as so I can cut them later.