05-28-2007, 01:01 PM
Made a whole lot of progress last night.
Mounted the stealth (Waiting on the bearings)
Made the driveshaft to the transfer case, It's overkill I know.
I also started work a bellcrank steering setup that looks like a steering box. I had to because of the transmission, the servo will be located further back on the chassis.
When I saw this drawer organizer at the hardware store I couldn't resist.
Instant truck bed.
Could also be used as a camper shell.
I shortened it up a little, then made wheel wells from a 3" PVC plumbing cap. I'll have to paint it later.
I want to get some kind of toolbox in the back to cover those goofy cab bars.
Battery will have to fit under the bed as I can't really find a place up front. The location shouldn't be too bad as the trans is so far forward. Fits quite well for not planing for it.
Seat still fits, But I think I will remake it anyway if just looks big and brite. I'll make it out of styrofoam to that way water won't effect it.
Mounted the stealth (Waiting on the bearings)
Made the driveshaft to the transfer case, It's overkill I know.
I also started work a bellcrank steering setup that looks like a steering box. I had to because of the transmission, the servo will be located further back on the chassis.
When I saw this drawer organizer at the hardware store I couldn't resist.
Instant truck bed.
Could also be used as a camper shell.
I shortened it up a little, then made wheel wells from a 3" PVC plumbing cap. I'll have to paint it later.
I want to get some kind of toolbox in the back to cover those goofy cab bars.
Battery will have to fit under the bed as I can't really find a place up front. The location shouldn't be too bad as the trans is so far forward. Fits quite well for not planing for it.
Seat still fits, But I think I will remake it anyway if just looks big and brite. I'll make it out of styrofoam to that way water won't effect it.