09-25-2007, 05:12 PM
Czech-it-Out Graphics Wrote:pick up a dubro pro balancer and grab a spare 17mm hub, i think it was like 30$ for the balancer at al's cant remember. Go down to michael's or a craft store and get some modeling clay for a whoping 2$
Put the tire on the balance and let it stop spinning on its own. mark the point directly above the center line on the rim, this is the High or light spot on the tire, this is where you will add clay. Add bits of clay until u can get that line to lay at 3 o clock or 9 o oclock or close to it. a real gentle spin is all u will need or it will take forever to stop spinning
alright thanks alot man. i would use just a mugen buggy or truggy hub? i heard buggy is better. Then arent i supposed to use some fuel line or sometinhg under it?