|
Deck Height???
|
10-11-2007, 05:23 PM
I will tell you that even with a dished piston the solder trick works. The piston is only dished in the center. Remove the plug bend the soder to an L put threw plug hole and you will feel it hit the side of the sleave. Rotate engine slowly till you feel the soder get pinched then turn over. Remove soder and check thikness with caliper.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Deck Height??? - by MX_KEVIN - 09-29-2007, 03:10 PM
Deck Height??? - by Czech-it-Out Graphics - 09-29-2007, 03:22 PM
Deck Height??? - by allan42r - 09-29-2007, 03:39 PM
Deck Height??? - by Czech-it-Out Graphics - 09-29-2007, 03:50 PM
Deck Height??? - by allan42r - 09-29-2007, 03:52 PM
Deck Height??? - by MX_KEVIN - 09-29-2007, 05:16 PM
Deck Height??? - by Ponch - 09-29-2007, 05:19 PM
Deck Height??? - by MX_KEVIN - 09-29-2007, 05:24 PM
Deck Height??? - by slaytanic - 09-29-2007, 06:28 PM
Deck Height??? - by rocco79 - 09-29-2007, 10:45 PM
Deck Height??? - by Chimer34 - 10-11-2007, 12:35 PM
Deck Height??? - by Tony D - 10-11-2007, 05:23 PM
Deck Height??? - by rocco79 - 10-12-2007, 05:28 PM
Deck Height??? - by allan42r - 10-13-2007, 01:55 AM
|
