ChitownRC › Tech Forums › Engine / Drivetrain v
Deck Height???

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Deck Height???
rocco79 Offline
Super Moderator
******
Posts: 13,181
Threads: 169
Joined: Jul 2004
Reputation: 0
#13
10-12-2007, 05:28 PM
Tony D Wrote:I will tell you that even with a dished piston the solder trick works. The piston is only dished in the center. Remove the plug bend the soder to an L put threw plug hole and you will feel it hit the side of the sleave. Rotate engine slowly till you feel the soder get pinched then turn over. Remove soder and check thikness with caliper.
Ron at werks says it does work tonyBig Grin
Dont mess wit my sig Line tune!
--Then follow the rules! haha!-- -Tune
Find
Reply


Messages In This Thread
Deck Height??? - by MX_KEVIN - 09-29-2007, 03:10 PM
Deck Height??? - by Czech-it-Out Graphics - 09-29-2007, 03:22 PM
Deck Height??? - by allan42r - 09-29-2007, 03:39 PM
Deck Height??? - by Czech-it-Out Graphics - 09-29-2007, 03:50 PM
Deck Height??? - by allan42r - 09-29-2007, 03:52 PM
Deck Height??? - by MX_KEVIN - 09-29-2007, 05:16 PM
Deck Height??? - by Ponch - 09-29-2007, 05:19 PM
Deck Height??? - by MX_KEVIN - 09-29-2007, 05:24 PM
Deck Height??? - by slaytanic - 09-29-2007, 06:28 PM
Deck Height??? - by rocco79 - 09-29-2007, 10:45 PM
Deck Height??? - by Chimer34 - 10-11-2007, 12:35 PM
Deck Height??? - by Tony D - 10-11-2007, 05:23 PM
Deck Height??? - by rocco79 - 10-12-2007, 05:28 PM
Deck Height??? - by allan42r - 10-13-2007, 01:55 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)