crt setup help

[MaxxGS]

You should be able to find Chad Bradley's set-ups sheet on-line on the Ofna site but if not this is from a friend in California that use to race the CRT and he sent this to me for someone else I was helping at one time.

Front:
5000 Diff oil
"B" suspension blocks
60wt Associated oil, stock springs & pistons
Shock position: Upper middle hole on tower, inside on arm
Middle Ackerman position
Upper roll-center upper hingepin position
-2 camber, +1 toe out
Proline Crime Fighter MT tires w/Racers Edge 2-stage foam

Middle:
3/4 filled w/10,000, 1/4 filled w/30,000 diff oil
Stock gearing, 13t clutch bell
UE / Supermaxx flywheel
UE / Supermaxx 3.0 aluminum shoes w/ 0.9 springs
Dace custom one piece motor mount

Rear:
3000wt diff oil
Stock anti-squat plate
Stock -2.5 deg. aluminum rear toe block
Middle wheelbase setting
Book camber link locations
55wt GS shock oil
Gray Mugen MBX-5 big-bore springs
Shock position: upper row, 3-holes out from innermost hole on tower, middle on arm
-2 camber
Proline Crime Fighter MT tires, Racers Edge 2-stage foam

Stock body, CRT body wyellow buggy wing cut 1/4-in. off each side & reattached.
Engine: Novarossi "EB Mod" 528XR engine
O'Donnell 97T glow plug
Byon 30% fuel
Mugen MSR1005 pipe/header