01-13-2008, 01:08 PM
OK....I bought new hubs, and have successfully dismantled the old components. The issues that I am facing are that I am able to get the bearing closest to the hex inserted to the new hub, but I cannot get the bearing inside the hub inserted....it is just a hair too tight. What tricks do you all know of to get the bearing inserted??? I have destroyed 2 bearings already in my attempts. Any advice would be appreciated. BTW I am doing this to a Cen Matrix.
Jeep_Guy (a.k.a Xirtic)
*CEN Matrix Buggy (Brushless)
*Duratrax Warhead EVO (Brushless)
*Axial AX10 Crawler (Brushless)
*RC18T (Brushless)
*CEN Matrix Buggy (Brushless)
*Duratrax Warhead EVO (Brushless)
*Axial AX10 Crawler (Brushless)
*RC18T (Brushless)