Chicaolands first indoor comp!!!

[BJoe]

That conversion works pretty decent, i think thats basically what Bjoe is doing. all-thread can be purchased at most hardware stores and I think HT has it. I personally would use brakeline and 6-32 all-thread with Dubro 6-32 rod ends. I would also recommend moving the servo to the axle and putting the batteries on the axle.

I picked the 6-32 allhtread I used on the lower steering pushrod at the St. Charles Ace Hardware, shouldn't matter where you go like Jeff said. For the LCA's and front tierods I used Lundsford Ti pushrods for the Revo because I wanted the simple adjustablility and put them on Savage tie rod ends. I'm going to be starting a second WK project that will be using the remaining 6-32 rod from the 3 ft piece I bought this summer since I don't think that there are Ti turnbuckles that are readily available.