ChitownRC › Main Forums › Racers Forum v
Dog Bones / Swing Shafts

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Dog Bones / Swing Shafts
Mr. Tune Offline
Administrator
*******
Posts: 3,897
Threads: 254
Joined: Jan 2020
Reputation: 0
#2
10-06-2004, 01:26 PM
Yep they make cvd's for all four corners. I've only bent 2 dogbones bad enough that they needed to be replaced. Stuck in the HD one's and left it at that. I was too cheap to spend the money on cvd's. Haven't broke any since.

I found that the key to not bending dogbones is to make sure you are not on the gas or brake when the truck lands from a jump. The 2 that I broke were a long time ago, when I was still a noob to nitro trucks.
Find
Reply


Messages In This Thread
Dog Bones / Swing Shafts - by NitroNoob - 10-06-2004, 12:48 PM
Dog Bones / Swing Shafts - by Mr. Tune - 10-06-2004, 01:26 PM
Dog Bones / Swing Shafts - by NitroNoob - 10-06-2004, 02:13 PM
Dog Bones / Swing Shafts - by rocco79 - 10-08-2004, 07:12 PM
Dog Bones / Swing Shafts - by NitroNoob - 10-08-2004, 10:26 PM
Dog Bones / Swing Shafts - by SixVi6-Camaro - 10-08-2004, 10:30 PM
Dog Bones / Swing Shafts - by rocco79 - 10-08-2004, 11:54 PM
Dog Bones / Swing Shafts - by NitroNoob - 10-09-2004, 03:27 PM
Dog Bones / Swing Shafts - by rocco79 - 10-09-2004, 03:28 PM
Dog Bones / Swing Shafts - by NitroNoob - 10-09-2004, 03:32 PM
Dog Bones / Swing Shafts - by Tex - 10-09-2004, 03:36 PM
Dog Bones / Swing Shafts - by NitroNoob - 10-09-2004, 03:39 PM
Dog Bones / Swing Shafts - by Tex - 10-09-2004, 03:53 PM
Dog Bones / Swing Shafts - by DO-U-MAXX - 10-09-2004, 08:30 PM
Dog Bones / Swing Shafts - by SixVi6-Camaro - 10-09-2004, 09:44 PM
Dog Bones / Swing Shafts - by NitroNoob - 10-10-2004, 07:28 PM
Dog Bones / Swing Shafts - by Tex - 10-10-2004, 09:03 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)