11-15-2005, 12:45 PM
You could just smear thick grease all around the servos at the case seams. That will keep water out unless you sink the buggy. Then you can wipe it off and degrease it later. Grease the output shaft where it exits the case to keep dirt and water out of there, too. Shoo goo the spot where the wires exit the servos.
Saw a neat trick about grease packing the outdrive cups to keep dirt from getting in there and causing wear. Grease pack and then a wrap of tape to keep the grease from flinging out or dirt getting in from the sides. Looked pretty logical to me.
Saw a neat trick about grease packing the outdrive cups to keep dirt from getting in there and causing wear. Grease pack and then a wrap of tape to keep the grease from flinging out or dirt getting in from the sides. Looked pretty logical to me.