Got bored, and it's snowing so I made these;
Sorry for the blurry pics, didn't want to take anymore tonight. It was out of a clear box (flexible platic with blue rubbery lid IDK...) so I cut it out, and used my mini torch to heat up the plastic to get the bend in front. Then I cut out the peice that has the wheel nut over it, and used the torch again to get it flexible enough that I could bend half of it forward and half back. Drilled holes, and put screws in. For the place where it mounts to the truck, I drilled holes the size of the round part past the threaded part, and put the pin and hex on after that as a spacer. Nut on after that. Then I disconnected the front drive shaft, except the one cup that has the two pins that make the brakes work, I took that off my removing the eclip which I launched into the stratosphere lol...So hopefully this'll work, seems good to me. Let me know and if your truck has skis feel to post...
Sorry for the blurry pics, didn't want to take anymore tonight. It was out of a clear box (flexible platic with blue rubbery lid IDK...) so I cut it out, and used my mini torch to heat up the plastic to get the bend in front. Then I cut out the peice that has the wheel nut over it, and used the torch again to get it flexible enough that I could bend half of it forward and half back. Drilled holes, and put screws in. For the place where it mounts to the truck, I drilled holes the size of the round part past the threaded part, and put the pin and hex on after that as a spacer. Nut on after that. Then I disconnected the front drive shaft, except the one cup that has the two pins that make the brakes work, I took that off my removing the eclip which I launched into the stratosphere lol...So hopefully this'll work, seems good to me. Let me know and if your truck has skis feel to post...
Tekno EB48.4 HobbyWing XR8 Sanwa M12