12-10-2005, 09:47 PM
i think revo2k might have a servo that will fit it, from when he had his mamba but i dont remember PM him, u can get a ball diff from any hobby shop that has 1/18th stuff, i have an MIP one. http://www2.towerhobbies.com/cgi-bin/wti...LXGZM2&P=7 just be sure not to over tighten the screw in the out put shafts, i did that and it snapped right off, also i had to drill out a little bit around the diff case because the new yolks were rubbing and it would bearly move. i have the rebuild kit if u need more of the balls, my advice would be to get a pringle lid, or a gartorade top or something like that and then magnatise a small screwdriver to pick up the balls because some of them are so small u can barely see them on the desk. just be careful, lol
8ight | Mini-T | CEN Boat | Stampede | JR R-1
ALL RC STUFF FOR SALE. PM FOR DETAILS.
ALL RC STUFF FOR SALE. PM FOR DETAILS.