12-13-2005, 03:51 PM
If you are going to plasti dip do it from the bottom up a decent bit past the seam. Then run a dab of grease around the base of the servo arm to prevent water from entering that way. I am taking it a step further. I am taking the servos apart and running a line of RTV gasket maker along it and then sealing it back up. I will then use the grease. I don't know if I will plasti dip also. Not sure. I will also be RTVing the actual boxes. It will keep them waterproof as well as what is inside. You should only do this if you have an externam charging jack... or else you will need to rip apart the gasket every time. I should be snow bashiung this weekend. After that just blow the truck off with an air compressor to make sure there is no snow/water left. May want to use some WD40 too... welcome and hope that helped.