01-26-2006, 11:16 AM
I sure will do that.
I will write up an official full review on this and post it.
If you think about it---not just for newbies really.
With LHR a bit on the dimmed side this makes it easier to see what you are doing and to really know how far you turned the screw.
Just in my RC room I can see this very clearly from sitting in my chair to the ground. Without it I have to take a second look to see where it is set at.
I am looking foraward to tuning my truck and break in another motor with this.
You can see the small adjustment you can make.
Just having it I can feel it was a good investment.
I will write up an official full review on this and post it.
If you think about it---not just for newbies really.
With LHR a bit on the dimmed side this makes it easier to see what you are doing and to really know how far you turned the screw.
Just in my RC room I can see this very clearly from sitting in my chair to the ground. Without it I have to take a second look to see where it is set at.
I am looking foraward to tuning my truck and break in another motor with this.
You can see the small adjustment you can make.
Just having it I can feel it was a good investment.
Life is like Beavers, One Damn thing after another- Unknown
If your not breakin parts your not going fast enough-Biodragen
NTC3 RTR assoc .15
NTC3 OS .18
Losi 8T, JR8611a ST servo, Futaba 9350 Th\Brk Servo, RB-C6BB Motor and Novarossi 528XR.
If your not breakin parts your not going fast enough-Biodragen
NTC3 RTR assoc .15
NTC3 OS .18
Losi 8T, JR8611a ST servo, Futaba 9350 Th\Brk Servo, RB-C6BB Motor and Novarossi 528XR.