01-31-2006, 03:58 PM
Hey I would get the OFNA clutch shim kit to.
I did this on mine and it helps.
There are a few tiny little washers in there and they are thin.
Put the ones that are closest to the flywheel pins size on before the shoes.
This will keep the shoes from dragging on the flywheel.
Keeps the friction from the shoes wearing on the flywheel leaving it to move more freely.
this was a tip from some place I can't remember.
I did this on mine and it helps.
There are a few tiny little washers in there and they are thin.
Put the ones that are closest to the flywheel pins size on before the shoes.
This will keep the shoes from dragging on the flywheel.
Keeps the friction from the shoes wearing on the flywheel leaving it to move more freely.
this was a tip from some place I can't remember.
Life is like Beavers, One Damn thing after another- Unknown
If your not breakin parts your not going fast enough-Biodragen
NTC3 RTR assoc .15
NTC3 OS .18
Losi 8T, JR8611a ST servo, Futaba 9350 Th\Brk Servo, RB-C6BB Motor and Novarossi 528XR.
If your not breakin parts your not going fast enough-Biodragen
NTC3 RTR assoc .15
NTC3 OS .18
Losi 8T, JR8611a ST servo, Futaba 9350 Th\Brk Servo, RB-C6BB Motor and Novarossi 528XR.