03-19-2006, 12:40 PM
I checked the crank shaft. That's not bent.
The CB isn't getting hot because as soon I killed the engine, I was able to put my finger on it and keep it there.
Slipper is backed off about half a turn. It's not the mesh. I make sure there is some play between the CB and spur.
Would I be able to figure it out if I just put a new spur on, have the wheels off the groung, and just rev the engine a little bit and see if the spur strips then?
The CB isn't getting hot because as soon I killed the engine, I was able to put my finger on it and keep it there.
Slipper is backed off about half a turn. It's not the mesh. I make sure there is some play between the CB and spur.
Would I be able to figure it out if I just put a new spur on, have the wheels off the groung, and just rev the engine a little bit and see if the spur strips then?
FS-Sportwerks 1/8 Hauler