03-21-2006, 12:23 AM
Take the shaft out of the trans on chuck it up on a 3/8 drill were the bit would go in the chuck. Then pull the trigger on the drill and watch the shaft. Providing you put the shaft in the drill chuck straight you will see if the shaft is bent when it's spinning. If it's wobbling it bent. Don't be confused It won't be 100% true but it should be very close because it needs to spin at 30,000 rpm so if it's bent it will run out of balance. This is kinda like putting a steel rod in a lathe to turn it down. This must sound crazy using a drill but I know for a fact it will work and give accurate results.
Supermaxx Predator Lite Race Maxx
Supermaxx Thunder Big-Block Race Truck
GS Storm SUT CE Native Racing Truck
Mugen MBX5T
Mugen MBX5R