ChitownRC › Main Forums › Racers Forum v
Just finished breaking in the 3.3...

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Just finished breaking in the 3.3...
Tex Offline
Super Moderator
******
Posts: 9,001
Threads: 126
Joined: Jul 2004
Reputation: 0
#18
04-15-2006, 02:33 PM
300 is no ouch, most motors are ok as long as they are between 200-300F. I had plenty of smoke pouring out. I'm not woried in the least bit. Compression and pinch didn't change so........

BTW, the difference between 270F and 300F is miniscule. 250F to 350F is a big difference.
Mugen MBX5T
RBS5
RB2045
Futaba 3PM
Hitec 5955, 5965
Find
Reply


Messages In This Thread
Just finished breaking in the 3.3... - by Ponch - 04-13-2006, 08:22 PM
Just finished breaking in the 3.3... - by Ponch - 04-13-2006, 08:28 PM
Just finished breaking in the 3.3... - by Ponch - 04-13-2006, 10:18 PM
Just finished breaking in the 3.3... - by rocco79 - 04-13-2006, 11:09 PM
Just finished breaking in the 3.3... - by rocco79 - 04-14-2006, 02:51 PM
Just finished breaking in the 3.3... - by rocco79 - 04-14-2006, 05:14 PM
Just finished breaking in the 3.3... - by Tex - 04-15-2006, 12:18 PM
Just finished breaking in the 3.3... - by Tex - 04-15-2006, 02:33 PM
Just finished breaking in the 3.3... - by Tex - 04-26-2006, 06:40 PM
Just finished breaking in the 3.3... - by rocco79 - 04-26-2006, 07:02 PM
Just finished breaking in the 3.3... - by bossdog - 05-02-2006, 11:58 AM
Just finished breaking in the 3.3... - by bossdog - 05-04-2006, 11:49 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  On Road Finished! slim 96 16,043 06-04-2007, 11:28 AM
Last Post: Thirdgen89GTA
  Almost finished McLaren F1 micro racer CowboySiR 7 2,147 02-11-2007, 06:35 PM
Last Post: motoxer4life
  Breaking in motors and tuning Biodragen 9 2,372 01-10-2006, 04:43 PM
Last Post: destroy_my_revo_15
  No more breaking Obsessive R/C 11 2,588 06-21-2005, 10:55 AM
Last Post: Tex
  breaking shocks Obsessive R/C 14 2,989 06-04-2005, 01:58 PM
Last Post: Tex

Forum Jump:


Users browsing this thread: 6 Guest(s)