Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
NooooOo!! I'm out of shims and the crank shaft snout is too short!
#1
Grr...SOOOOoo close to getting the OS .30vg to fire in the buggy. But the shaft is about 1mm too short so the hex screw that holds the clutch bell ends up putting pressure on the bearings.

And I don't have the washers to shim it, need to visit the hobby shop tomorow. Its always the little things!Confusedmash:
Reply


Messages In This Thread
NooooOo!! I'm out of shims and the crank shaft snout is too short! - by Thirdgen89GTA - 08-25-2006, 09:24 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  looking for a front drive shaft assem for a mbx5 eraser 17 5,143 11-15-2007, 04:52 PM
Last Post: Czech-it-Out Graphics
  rust on the crank is it normal cheesecake 27 6,437 09-01-2007, 07:55 AM
Last Post: cheesecake
  crank AddictedtoNITRO 10 3,455 09-20-2006, 07:36 PM
Last Post: AddictedtoNITRO

Forum Jump:


Users browsing this thread: 1 Guest(s)