09-11-2006, 08:20 PM
I too have never dealt with that.
I use a heat gun in between coats.
I use a brush and not a sponge and with each coat
I also alternate direction of application.
I do this 3-4 times.
Then I cut a triangle in an area that I don't have to worry about and pull from the center. If I get it up without breaking I am good--if not it needs another coat.
Since I started doing this---I have had no more LMF issues when pealing it offand it is much easier than it being to thin which sounds like you are thin.
Just my thought on it
I use a heat gun in between coats.
I use a brush and not a sponge and with each coat
I also alternate direction of application.
I do this 3-4 times.
Then I cut a triangle in an area that I don't have to worry about and pull from the center. If I get it up without breaking I am good--if not it needs another coat.
Since I started doing this---I have had no more LMF issues when pealing it offand it is much easier than it being to thin which sounds like you are thin.
Just my thought on it
Life is like Beavers, One Damn thing after another- Unknown
If your not breakin parts your not going fast enough-Biodragen
NTC3 RTR assoc .15
NTC3 OS .18
Losi 8T, JR8611a ST servo, Futaba 9350 Th\Brk Servo, RB-C6BB Motor and Novarossi 528XR.
If your not breakin parts your not going fast enough-Biodragen
NTC3 RTR assoc .15
NTC3 OS .18
Losi 8T, JR8611a ST servo, Futaba 9350 Th\Brk Servo, RB-C6BB Motor and Novarossi 528XR.