08-13-2005, 10:46 PM
Mugen wing stay (wing mount) P/N - C0408
3mm Locking Nuts
4mm spacer (I used a 3mm since I had one in the pit box, looks fine to me)
A few 3mm washers.
3x30mm Cap screws (they are on the long side and I just cut off what I didn't need).
I picked up a TT (thunder tiger) wing, because it comes in black. Wings don't come pre drilled, so you can pretty much use the wing of your choice.
You'll need to drill holes into the rear body mount tower to accomplish the mod. The wing stay kit was $17 at LH and the wing was $7 at Al's. Hardware will be a few bucks if you don't already it in your pit box.
I followed the directions in this thread... http://monster.traxxas.com/showthread.ph...ight=c0408
3mm Locking Nuts
4mm spacer (I used a 3mm since I had one in the pit box, looks fine to me)
A few 3mm washers.
3x30mm Cap screws (they are on the long side and I just cut off what I didn't need).
I picked up a TT (thunder tiger) wing, because it comes in black. Wings don't come pre drilled, so you can pretty much use the wing of your choice.
You'll need to drill holes into the rear body mount tower to accomplish the mod. The wing stay kit was $17 at LH and the wing was $7 at Al's. Hardware will be a few bucks if you don't already it in your pit box.
I followed the directions in this thread... http://monster.traxxas.com/showthread.ph...ight=c0408