Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Is This Safe?
#1
I went out today to run a tank of my new fuel after tuning it a couple days ago. I knew the grass was lower than the curb where I was driving, but I guess it was lower than I thought. I don't remember how fast I was going, but it couldn't have been that fast because I knew there was a big bump.

I hit the curb with my front skid plate. The truck stopped. Tried hitting the gas and the motor would rev, but the truck wouldn't move. The engine slid over because the engine mount screws were not tight enough (I do use locktite, I don't know how they came loose) and my wire ties on my rx and rx pack broke.

I am wondering if it is safe to put the Rx pack in front of the shock tower like this. My main concern is that my skid doesn't come up at all.
[Image: rx1.jpg]

This is how I had it.
[Image: rx2.jpg]
FS-Sportwerks 1/8 Hauler
Reply
#2
From the pics, you're just asking for the rx power wires to get cut by some freak of nature accident having them all exposed like that. No where else to strap it down?
Reply
#3
Should have said that that's not how I plan on routing them. They will be safe.
FS-Sportwerks 1/8 Hauler
Reply
#4
I have a different idea. Is it ok to run the receiver not in a rx box. Is it ok to get dirty?
FS-Sportwerks 1/8 Hauler
Reply
#5
Just put a ballon over the reciever and zip-tie the ballon shut.
IT'S ALL ABOUT THE PAIN; THE INK AND THE JEWELRY ARE JUST SOUVENIERS
Reply
#6
I was thinking of doing that, but the balloon will hold moisture.
FS-Sportwerks 1/8 Hauler
Reply
#7
I ran my receiver without an RX box on my pred.
Mugen MBX5T
RBS5
RB2045
Futaba 3PM
Hitec 5955, 5965
Reply
#8
UE-Maxx Wrote:I have a different idea. Is it ok to run the receiver not in a rx box. Is it ok to get dirty?

It gets dirty inside the rx box on my truck! Just don't get it near the fuel tank or you might splash it when refueling. Balloon can't hurt.
got paint?
Colors by Dave - CBD
1-29-07 ... you know.
Reply
#9
my sugesion is to get a flat pack and put it under your chassis next to the center braces. not only will it be out of the way but will lower your center of gravity.
Gary Wright
President
http://www.midwestnitro.com
"Keeping Racing Simple"
Reply
#10
the balloon is fine, as long as it isnt wet when you put it in there, i put one ziptie around the neck of the balloon, and then i put another one around the base of the neck
8ight | Mini-T | CEN Boat | Stampede | JR R-1

ALL RC STUFF FOR SALE. PM FOR DETAILS.
Reply
#11
Thanks. I am in the middle of testing a few different locations and so far none of them are working.
FS-Sportwerks 1/8 Hauler
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Fail safe FAILURE!!!! Obsessive R/C 14 2,820 08-07-2005, 09:37 PM
Last Post: TowShen

Forum Jump:


Users browsing this thread: 1 Guest(s)