Posts: 906
Threads: 86
Joined: May 2005
Reputation:
0
hey im installing some new rear hubs on my mayhem buggy so i can run it tmo, and like im trying to get the hex off so i can take out the axle and bearings and put it in the new hub but i can figure out how to get it off...like i undid the screw in the center of the hub and i was pretty sure that was it but nadda. then i just am stuck nand have no clue how to do this... so if you could help me asap so i can have it running to run it tmo morning for a little while that would be AWESOME!!!
Thanks
John
Posts: 13,431
Threads: 106
Joined: Nov 2005
Reputation:
0
tap the pin out after u take out the set screw...in the middle of the hub there is a pin holding the hub to the axle
Here is a link to my website-
http://www.czech-it-out-graphics.com
1/29/07 never forget....TTT 
alute:
Bringing old know-it-all blow hards back to reallity at a forum near you
"Always Imitated, Never Duplicated"
Posts: 906
Threads: 86
Joined: May 2005
Reputation:
0
so i should be able to just lightly tap it with liek a flat nail and pop it out of there? thanks...
Posts: 13,431
Threads: 106
Joined: Nov 2005
Reputation:
0
or a screw driver or whatever just hit the pin and nothin around it, should come right out
Here is a link to my website-
http://www.czech-it-out-graphics.com
1/29/07 never forget....TTT alute:
Bringing old know-it-all blow hards back to reallity at a forum near you
"Always Imitated, Never Duplicated"
Posts: 906
Threads: 86
Joined: May 2005
Reputation:
0
thanks much...i felt like that was it, and i got it fixed in a jiffy. i cant wait to test it out tmo morning.....i got a nice open field and a skatepark that it will be too coldfor skaters to be at... so i got that to myself.
John
