Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
NooooOo!! I'm out of shims and the crank shaft snout is too short!
#1
Grr...SOOOOoo close to getting the OS .30vg to fire in the buggy. But the shaft is about 1mm too short so the hex screw that holds the clutch bell ends up putting pressure on the bearings.

And I don't have the washers to shim it, need to visit the hobby shop tomorow. Its always the little things!Confusedmash:
Reply
#2
lol
Tekno EB48.4 HobbyWing XR8 Sanwa M12
Reply
#3
I ended up taking a hard nose dive after the triple at LH on thursday. lost a spring, and the spring perch.

But someone found it today. :joy:

Too bad I already swapped the front springs from my Ultra comp 2 as a temp solution.
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  looking for a front drive shaft assem for a mbx5 eraser 17 5,040 11-15-2007, 04:52 PM
Last Post: Czech-it-Out Graphics
  rust on the crank is it normal cheesecake 27 6,381 09-01-2007, 07:55 AM
Last Post: cheesecake
  crank AddictedtoNITRO 10 3,387 09-20-2006, 07:36 PM
Last Post: AddictedtoNITRO

Forum Jump:


Users browsing this thread: 1 Guest(s)