Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Gel cell battery question
#26
Czech-it-Out Graphics Wrote:well atleast im using the right color powerband Smile


yeah duh
yellow
Reply
#27
red
Here is a link to my website-
http://www.czech-it-out-graphics.com
1/29/07 never forget....TTT Confusedalute:
Bringing old know-it-all blow hards back to reallity at a forum near you

"Always Imitated, Never Duplicated"
Reply
#28
red means too lean

install a shim on the opposite side so it'll run rich.
got paint?
Colors by Dave - CBD
1-29-07 ... you know.
Reply
#29
above or below the johnson rod?
Here is a link to my website-
http://www.czech-it-out-graphics.com
1/29/07 never forget....TTT Confusedalute:
Bringing old know-it-all blow hards back to reallity at a forum near you

"Always Imitated, Never Duplicated"
Reply
#30
If you use the Lamson socket it's above. But then you have to make an adjustment on the flay rod, because it will be out of skew on the tredle.
got paint?
Colors by Dave - CBD
1-29-07 ... you know.
Reply
#31
ahhh of course the tredle how could i forget! But dont forget the best performance upgrade u can get is a mag coated double piston divider, raises compression ya know
Here is a link to my website-
http://www.czech-it-out-graphics.com
1/29/07 never forget....TTT Confusedalute:
Bringing old know-it-all blow hards back to reallity at a forum near you

"Always Imitated, Never Duplicated"
Reply
#32
You lose...you actually used 2 real items in that one!!
got paint?
Colors by Dave - CBD
1-29-07 ... you know.
Reply
#33
i couldnt come up with any new words lol
Here is a link to my website-
http://www.czech-it-out-graphics.com
1/29/07 never forget....TTT Confusedalute:
Bringing old know-it-all blow hards back to reallity at a forum near you

"Always Imitated, Never Duplicated"
Reply
#34
snakebite46 Wrote:Ya know, Dodge Stealth and Mitsu 3000GT back in the day actually had muffler bearings FYI =)
New audi's use them to!

I'm suprised no halogen or blinker fluid came into the mix! Also you can't forget to check your 710 fluid!
IT'S ALL ABOUT THE PAIN; THE INK AND THE JEWELRY ARE JUST SOUVENIERS
Reply
#35
squirrel Wrote:Also you can't forget to check your 710 fluid!

LOL I could honestly see a person doing that.
Reply
#36
rc's don't use halogen, it's argon.
got paint?
Colors by Dave - CBD
1-29-07 ... you know.
Reply
#37
710 = Blond OIL
Reply
#38
Is that in the flux capacitor?

Quote:710 = Blond OIL
Finally someone else knew that! Also it's blonde!
IT'S ALL ABOUT THE PAIN; THE INK AND THE JEWELRY ARE JUST SOUVENIERS
Reply
#39
Can't be.
Reply
#40
Czech-it-Out Graphics Wrote:piranaha

dan the dudes been sick at radical, its gonna be a couple more days
No rush man.... I don't have cash right now anyway. Getting a KILLER deal on a $5600 mountain bike ($1500). I sold my board, and as soon as my bike sells I will have the cash to play with.
Reply
#41
FreeRideFrosty Wrote:No rush man.... I don't have cash right now anyway. Getting a KILLER deal on a $5600 mountain bike ($1500). I sold my board, and as soon as my bike sells I will have the cash to play with.
Lets try to keep this on topic now!!! Jesus!
IT'S ALL ABOUT THE PAIN; THE INK AND THE JEWELRY ARE JUST SOUVENIERS
Reply
#42
Blonds! sheesh....Rolleyes
got paint?
Colors by Dave - CBD
1-29-07 ... you know.
Reply
#43
thats cool man just letting u know
Here is a link to my website-
http://www.czech-it-out-graphics.com
1/29/07 never forget....TTT Confusedalute:
Bringing old know-it-all blow hards back to reallity at a forum near you

"Always Imitated, Never Duplicated"
Reply
#44
Dan you already got your no seat post bike....CHILL! lol
Tekno EB48.4 HobbyWing XR8 Sanwa M12
Reply
#45
Ponch Wrote:Dan you already got your no seat post bike....CHILL! lol

I need a bike for race season. I am getting a full carbon fiber frame, all top of the line (litterly the best made) components, EVERYTHING for $1500. It is a $5600 bike. I cannot pass up this deal.... It won't happen again. Once I sell my other bike and have this one I will have some coin to throw at all that stuff for the LSP. Big Grin
Reply
#46
My box does both. I prefer stick packs but the box that starts the kyosho uses a Gel cell so I modified it to accept both. when the gel runs out I use a home made y splitter with bullet tabs that plug directly into the side of box. so I take two stick packs with me for insurance, downside is a heavy tool box but I've been there with charged up gel only to have it crap out on me.
Reply
#47
I'm going to 2-7.4volt li-po batteries on my next box. I can get 5000 mah and they weigh so much less.
Reply
#48
better get a regulator man thats alotta draw
Here is a link to my website-
http://www.czech-it-out-graphics.com
1/29/07 never forget....TTT Confusedalute:
Bringing old know-it-all blow hards back to reallity at a forum near you

"Always Imitated, Never Duplicated"
Reply
#49
So I recharged the two best stick packs I own and setup my dual 550 motor box to fit the TTR, but it won't spin the motor over. Do need a box with the single BIG motor, or does this engine (pretty new) just need to loosen up some? What do y'all have in your box to start a truggy with a .28 motor?
Thanks
Reply
#50
if it has alot of pinch you may have to warm the engine alittle.... Or get alittle fuel in the motor that helps . Make sure you motor is at BDC that will help too

woah.. Sorry cant make sentences yet this morning...
Dont mess wit my sig Line tune!
--Then follow the rules! haha!-- -Tune
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  maxx .26 question towman 1 3,225 01-02-2011, 03:15 AM
Last Post: Racin' Ranger1
  question about a vspec engine eraser 83 16,779 02-06-2008, 04:36 PM
Last Post: J-Dub
  new vspec question eraser 2 2,071 11-04-2007, 08:51 AM
Last Post: chickenfarmer3
  question about a new motor eraser 20 5,551 10-14-2007, 12:39 AM
Last Post: willitbme15
  question about rc stuff rayk504 1 1,907 09-04-2007, 03:53 PM
Last Post: Mr. Tune
  8ight Clutchbell Question motoxer4life 19 5,496 07-16-2007, 09:53 PM
Last Post: cr4sh_27
  clutch bell question eraser 2 2,227 04-21-2007, 12:30 PM
Last Post: rocco79
  clutch nut question mikev 11 3,824 04-19-2007, 07:43 AM
Last Post: MX_KEVIN
  OS 18 tm question Meatwad 4 1,928 02-27-2007, 06:59 PM
Last Post: Mr. Tune
  am I just stupid? (revo question) stratcat 23 5,949 02-27-2007, 10:46 AM
Last Post: Tex

Forum Jump:


Users browsing this thread: 1 Guest(s)