Posts: 2,550
Threads: 145
Joined: May 2005
Reputation:
0
Anyone know the needle settings for a Picco P3 .26??
This thing will not start. Changed out the OWB added a P/S
I've changed the plug...eveything checks out. Messed with the needles...
It will not even sputter...seems tight w/ decent compression...
Everything seems fine, just can't get it to start. :confused:
Posts: 4,630
Threads: 81
Joined: Jul 2004
Reputation:
0
is your glow ignitor charged?
Posts: 1,330
Threads: 91
Joined: Nov 2005
Reputation:
0
Take the glow plug out and put it to your ignitor see if it glows.
Then see if its fluding, take glow plug out and give it a few good tugs.
Check if your fuel lines are cloged. Prime the engine and watch if fuel is going to the engine.
Mugen MBX5T Prospec
RB C6bb/O.S. Speed
Hitec 5955
Futaba s9351
Jr Z-1
http://www.frontlinetec.com
Soo easy a cave man can drive it Mooooooooooogen
Posts: 13,431
Threads: 106
Joined: Nov 2005
Reputation:
0
u cant go wrong with leaning it out ONLY to get it started, once it starts keep a very close eye on the smoke and temps. My Xp was like 7turns out from flush on the low end and flush on top
Here is a link to my website-
http://www.czech-it-out-graphics.com
1/29/07 never forget....TTT 
alute:
Bringing old know-it-all blow hards back to reallity at a forum near you
"Always Imitated, Never Duplicated"
Posts: 2,550
Threads: 145
Joined: May 2005
Reputation:
0
Glow plug lights up instantly, all lines are fresh and primed, it's not flooded and igniter is fully charged....still nothing.
Any other suggestions?
Posts: 4,630
Threads: 81
Joined: Jul 2004
Reputation:
0
do you see the fuel going through the lines and into the carb?
Posts: 4,630
Threads: 81
Joined: Jul 2004
Reputation:
0
make sure your needles arent closed
Posts: 2,550
Threads: 145
Joined: May 2005
Reputation:
0
I think it may be something in the carb.
![[Image: mich1iy1.jpg]](http://img172.imageshack.us/img172/9408/mich1iy1.jpg)
