02-26-2007, 01:56 PM
do'oh! I have that, along with a new pipe..
when I place the engine in the mount, the block and mount will line up on one side, but when you sneak a peak around the other side (inboard) there's a couple mm gap that absolutely will not allow the engine to mount, it looks like there is too much meat (aluminum) under the case to allow it to fit in that engine mount...
I'd rather use the OS engine, but I guess I'm going to go with the TRX if I can't make it fit without JB weld or duct tape..
when I place the engine in the mount, the block and mount will line up on one side, but when you sneak a peak around the other side (inboard) there's a couple mm gap that absolutely will not allow the engine to mount, it looks like there is too much meat (aluminum) under the case to allow it to fit in that engine mount...
I'd rather use the OS engine, but I guess I'm going to go with the TRX if I can't make it fit without JB weld or duct tape..
"if guns cause crime, all of mine are defective" - Ted Nugent